Emtek Keypad Leverset Locksets Manual de usuario

Installation & Programming GuideKeypad Lever LocksetsASSA ABLOY, the global leader in door opening solutions

10In order to perform each of the following six functions, the lock must rst be placed in Programming Mode:*If no input within 10 seconds, Yellow LED

11IN8-KEYPADLL1 09/27/2010Restoring the Lock to Factory Default Setting• Remove power (disconnect 9V battery) from Lock • Press and Hold EMTEK butto

ASSA ABLOY is the global leader in door opening solutions, dedicated to satisfying end-user needs for security, safety and convenience.Copyright © 201

24354b4a214c4d7668ITEM NO. DESCRIPTION QTY.1 Metal Key 22 Outside Trim Plate Assembly 13 Latch Assembly 2 ⁄” or 2 ¾” Backset14 Inside Trim Plate Ass

32 ⁄” or 2 ¾” Backset2 ⁄” Diameter Bore⁄” Deep2 ¼”1 “1” Diameter Edge Bore3. Remove Screws from Inside Trim Plate2. Door Prep3. Door Jamb Prep1

4Use a Phillips head screwdriver to remove screws (item #4c) shown below and detach Inside Trim Plate from the Inside Chassis.Screws (item #4c)2. Remo

53. Install Outside Trim Plate AssemblyStep 1: While holding Outside Trim Plate Assembly, Press the Plastic Extender (A) into end of Spindle Shaft (B)

64. Install Inside ChassisCAM LINK MUST REMAIN IN THE CORRECT POSITION DURING INSTALLATION.!Step 1: Conrm the position of Cam Link.For Left Hand Loc

7Step 4: Connect Wire Harness (A) and tuck Connectors as shown (B).ABStep 5: Install Battery.For optimal performance, always use a good quality bat

8*Locked position is required for installation and removal of the Inside Trim Plate Assembly. (Does not apply to Keypad Storeroom/Gate product) *Lock

9Your Emtek lock is shipped with two 4-digit user codes and a 6-digit programming code. These codes are randomly generated at the factory. (Turn to ne